...
Install the serial terminal Termite if you don’t have one already installed.
Using a serial cable, physically connect the device to your computer by pins 7/8/9 (above).
In Termite use the settings below to connect to the device.
Power on the device, you will have a 30 second window to connect through your serial interface after start-up by pressing any key. Restart the device if you miss thisthe timeout.
| Note |
|---|
The COM port will be dependent on your PC and how many devices you have connected (COM4 is an example). The port can be found under your PC’s device settings. |
...
Configure device settings
Now you are connected you can configure your Device device.
All devices device's have some common settings to set the mode, sleep/wake cycle and time.
Most devices have additional commands specific to that device. These can be found under your device family's documentation page.
| Info |
|---|
If you require more info regarding configuration of your device , don't hesitate to call Contact us.! |
Related articles
| Filter by label (Content by label) | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Page Properties | ||
|---|---|---|
| ||
|