Sensus Meitwin

Remove the lid of the box by unscrewing the 4 screws on top
Unscrew the cap of the gland and remove the rubber grommet found inside.
Pass the cap of the gland through the water meter cable and then pass the rubber grommet afterwards.
Pass the cable of the meter through the gland into the inside of the box.
Now that the wires are inside the package they are to be connected to the board through the green connector. Hold down connector buttons to open and release the individual connections. Connect wires according to the figure below.

White	Empty	Brown (left )	Brown (right)	Red	Black

White	Empty	Brown (left )	Brown (right)	Red	Black
GND (left)	Tamper	Count 2	Count 1	3V	GND (right)

Count 1 logs each pulse from one of the water meters and Count 2 the other meter (the higher resolution of the two).

Knowledge Base